Victron MultiPlus 12/1600/70-16 230v VE.Bus
Shipped in 1-3 days
The MultiPlus 12/1600/70-16 (Victron Energy, pmp122160000) is a modern device combination consisting of a powerful 12v 1300w sine wave inverter, an advanced 70a battery charger that uses adaptive charging technology and a 16a high-speed AC voltage transfer switch.
In the event of a mains fault or if the shore power or on-board generator is interrupted, the Multi's inverter is automatically switched on and takes over the supply to the connected loads. The switchover happens so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic devices is guaranteed.
key features of the MultiPlus 12/1600/70-16
- Cont. Output power at 25°c: 1300w with non-linear load
- Victron Energy mpn: pmp122160000
- for 12v system voltage
- integrated 70a mains charger for your batteries
- integrated 16a mains transfer switch
- UPS operation possible, PowerAssist and PowerControl function
- Extensive range of accessories available
- Can be used in numerous areas of application, whether on land or mobile
proven reliability
Complete bridging with an additional toroidal transformer topology has proven itself over many years. The inverter is short-circuit-proof and protected against overheating (whether caused by overload or ambient temperature).
PowerControl - (only Multiplus 800va 1200va and 1600va)
The maximum mains or generator current to be drawn can be set using the Multi Control remote control panel. The MultiPlus then takes other connected AC consumers into account and only uses the power that is still "left over" for charging. This prevents the generator or shore power connection from being overloaded.
PowerAssist - (Multiplus 800va 1200va and 1600va only)
Load peaks often only occur for a limited period of time. In such cases, the MultiPlus ensures that insufficient shore power or generator output is immediately compensated for by energy from the battery. If the load is reduced, i.e. consumers are switched off, the available energy can then be used to charge the batteries again.
High switch-on power
This is required to switch on loads with high inrush currents, such as voltage converters for LED lamps, halogen lamps or power tools.
Search mode
If the search mode is set to 'on', the power consumption of the inverter is reduced by approximately 70% in no-load operation. In this mode, if the Multi is operated in inverter mode, it switches off at zero load or at low load and a sensor measures the current output current every 2 seconds. If the output current exceeds a set limit value, the inverter resumes operation. If this is not the case, the device remains in energy-saving search mode.
programmable relay
In the default setting, the multifunction relay acts as an alarm relay, i.e. it switches the device off in the event of faults (device gets too hot, ripple voltage at the input too high, battery voltage too low).
Scope of delivery:
1x Victron Energy pmp122160000 MultiPlus 12/1600/70-16 1x operating instructions