Victron Battery Protect BP-100 12V 24V 100A

The Victron Battery Protect BP-100 (MPN BPR000100400) disconnects the battery from less important consumers before it is completely discharged (which would damage it) or before it no longer has sufficient energy to start the engine, etc. In addition, the BP series has overvoltage protection that switches off the load at 16V or 32V battery voltage and protects it from damage. The BP supports AGM, lead-acid, gel, and lithium batteries. Under no circumstances should an inverter be connected to the Victron Battery-Protect BP-100!

6 different shutdown thresholds can be set

The Battery Protect is very flexible and can be set to different cut-off voltages. The following cut-off thresholds can be activated on the device: 10.5V / 21V, 10V / 20V, 9.5V / 19V, 11.25V / 22.5V, 11.5V / 23V, 11.8V 23.6V

In addition, there are different restart thresholds that can be selected for most shutdown thresholds. This makes this device the perfect protective device for your battery and ensures maximum service life, because although most voltage converters or charge controllers have undervoltage protection, this only kicks in at fairly low values, usually in the range of 10.5V / 21V. The higher this shutdown threshold, the longer you will enjoy your batteries, which are usually quite expensive.

Selecting the cut-off threshold

Depending on the battery type, different minimum battery voltages apply that must be maintained in order not to damage the battery. For AGM/gel batteries, we recommend setting the Batteryprotect to a 11.5V shutdown threshold. For lithium batteries (LifePo4), a 12.0V shutdown threshold is recommended. Depending on the intended use of the battery, it may be necessary to change these limits. Manufacturers also provide different information about their batteries. Therefore, always check with the battery manufacturer to find out which cut-off threshold is right for your battery!

Summary of key product features

• For 12V and 24V batteries with automatic detection of the voltage range of the battery bank
• 6 different cut-off voltages selectable
• 100A maximum continuous current
• Easy programming and status display of settings via seven-segment display
• Extra mode for lithium batteries – in this mode, the BP can be controlled by the VE.Bus BMS
• very low power consumption
• Explosion protection through integrated MOSFET switches that replace the relays and thus reduce the risk of sparking to zero
• integrated alarm output

Output for delayed alarm

The alarm output is activated when the battery voltage falls below the preset shutdown value for more than 12 seconds. Starting the engine therefore does not activate the alarm. The alarm output is a short-circuit-protected open collector output connected to the negative (minus) rail. Max. current 50 mA. The alarm output is normally used to activate an acoustic signal, an LED, or a relay.

Load shutdown and reconnection delay

The load is disconnected 90 seconds after the alarm is activated. If the battery voltage rises again to the reconnection threshold within this period (for example, after the engine has been started), the load is not disconnected. The load is reconnected 30 seconds after the battery voltage has exceeded the specified reconnection voltage.

Scope of delivery:
1x Victron BPR000100400 BP-100 battery protection 100A 12V 24V
1x Operating instructions