Cable for Smart bms cl 12-100 to MultiPlus
Shipped in 1-3 days
This interconnect cable from Victron Energy (mpn ass070200100) connects a non-VE.Bus bms (smart bms cl 12/100 or smallbms) to a MultiPlus (MultiPlus, MultiPlus Compact or MultiPlus-II). The cable turns off the MultiPlus once the bms has detected a low voltage, high voltage, or temperature alarm condition in the Victron lithium iron phosphate (LiFePO4) smart battery bank. Once the alarm condition is resolved, the bms will turn the MultiPlus back on.
Compatible with:
- MultiPlus 500va - 1600VA
- MultiPlus Compact 800va - 2kVA
- MultiPlus-II
- Control via load/charger disconnect outputs or load/charger outputs
The cable must be wired to the remote on/off connector on the MultiPlus models:
- When used with MultiPlus 500va - 1200va models, connect the black wire to the ON terminal and the red wire to the (+) terminal
- When used with MultiPlus Compact 800va - 2kVA models, connect the black wire to the center terminal and the red wire to the right (in) terminal
- When used with MultiPlus II models, connect the black wire to the bottom (-) terminal and the red wire to the top (+) remote on-off terminal.
Both the load/charge disconnect outputs of the smart bms cl 12/100 and the load/charge disconnect outputs of the smallbms must be in the 'high' state for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the bms to reset the system. The MultiPlus will then turn on and begin charging (if connected to an AC power source).
Scope of delivery:
1x Victron Energy connection cable for Smart bms cl 12/100 to MultiPlus (ass070200100)